Introduction to the working principle and installation method of aquarium aerator

If you raise fish at home, you will prepare a fish tank for the fish to let the fish survive in the fish tank. However, the lack of oxygen in the aquarium will cause the fish to die. At this time, it is necessary to install a fish tank aerator in the fish tank. Many people will pay attention to it. Let's take a look at the working principle and installation method of the aquarium aerator.

First, the working principle of the aquarium aerator

The working principle of the aquarium aerator is the same as that of the industrially used aeration pump, which allows oxygen to enter the water by pressing air into the water. Because the air and the water body are in full contact, the oxygen molecules will be melted into the water, so that the dissolved oxygen amount is increased, and the fish in the water are better produced.

The power of the aquarium aerator is much smaller than that of an industrial aeration pump. Too much power can cause severe water pressure to damage plants in fish and water. So we saw that the aquarium aerators in the aquarium spit out a string of small bubbles. Although the aquarium aerator has a small power, it has a very large effect, and it is difficult to raise fish without it.

Second, the introduction of the installation method of the aquarium aerator

1. First place a long sponge on the bottom of the aquarium, install the leaking parts under it, and then fix the sponge on the card slot with the clamping parts.

2. Connect the water pump of the aquarium aerator to the long plastic tube. Remember that the filter needs to be installed to prevent the dross from entering the pump and destroying the inside of the aquarium. Then connect the hose part of the lance, and the oxygen vent should be fixed upward at the bayonet.

3. Connect the curved pipe to the oxygen outlet and lock the position; then connect the curved pipe and the water filter pipe together. There is a row of small holes on the water filter pipe, and the small hole should be turned downward.

4. Now connect the power plug of the aquarium aerator to the socket, add enough water to the aquarium, and then open it to see the oxygen supply effect. If the blisters are not going well, first turn off the power before making adjustments.

The working principle and installation method of the aquarium aerator are as follows. The function of the aquarium aerator is to help the fish in the aquarium to bring oxygen and prevent the fish from dying due to lack of oxygen. If there is fish in the aquarium, the aquarium aerator must be kept open. If the aquarium aerator is not open, its function cannot be fully utilized.