[ Chinese wardrobe net ] Wardrobe is a must-have for our home. The clothes you wear need a warm place to put in, and the wardrobe is very important. Of course, how to install is also very difficult for everyone, then let Xiaobian tell everyone how to install the wardrobe.
How to install the wardrobe
1. Check the accessories: Open the package, and then check whether the accessories inside are complete. There is a manual, and check the instructions. If there are few, it is estimated that you can't install it without using it. Therefore, the number is clear in advance, so as not to be wasted. Always wear gloves when installing, and be sure to read the instructions carefully.
2, the first to install the bottom: first install the bottom is a piece, take out the bottom with a high four-way joint, the middle is connected with a short tube. Install a four-way joint on each side, then install the tube on both sides, and decide the position to be placed. Install a long tube on one side and a short tube on the other. Then install the base fabric on both sides, and then install a three-way joint around each other.
3, set of wardrobe cloth cover: After installing the bottom, insert six short steel pipes, and then face the surrounding holes, the whole wardrobe cloth set up. Then install a layer of the bottom of the partition, and then put it on the six steel pipes.
4, the short side of the floor: If the wardrobe is divided into two sides, first install the short side of the floor, first insert the side of the steel pipe, then install the cloth, then connect the four-way joint, and then install two horizontal steel pipe Then install the spacer and then make up the four-way connector on both sides. Repeat the baffle until it is attached to the top.
5. Long-side steel pipe: After the short-side partition is installed, the long side is a vertical hanging area, and a three-way joint is used to connect the two long pipes to the top.
6. Install the top steel pipe: After both sides are installed, connect them directly with long steel pipes, so that the wardrobe is installed. If the wardrobe is too high and not enough to squeeze, it is recommended to push the side back. So as not to be installed. At the same time, the hanging steel pipe can also be installed with a hook type joint, which is relatively simple.
7, set of wardrobe cloth cover: When the top of the large set, it is best to pull the bottom to the top, so that there is space to pull on the top, until the upper corner is installed diagonally, you can pull the cloth cover down. The wardrobe is now installed.
The above is a brief introduction to how to install the wardrobe, I hope to help everyone.
Cleaning Paste,Norwex Cleaning Paste,Norwex Cleaning Paste Grout,Multi Purpose Cleaning Paste
Shandong Tianzige International Trade Co., Ltd , https://www.chinesedipers.com